التظهير خطوة خطوة .. كتاب طبع وتحميض الصور الفوتوغرافية

B - Endorsement step by step:

1- Prepare the necessary materials: Bring three large cups. It is preferable that these cups be numbered so that you know the exact quantities that you will need to avoid any waste. Fill each of them with one of the work solutions for the appearance, the stopper bath and the stabilizer. The amount of the solution needed depends.

on the capacity of the tank.

Numbered cups for measuring the solutions that will be used

2- Determine the time required for endorsement with the help of the instructions that come with the endorsement. Then measure the temperature of your applicator by dipping a photographic thermometer into it for two minutes. The instructions accompanying the display solutions usually specify the temperature that will provide you with an excellent drip and granulation.
24- Match the temperature of the used apparel
In order to reach the temperature recommended by the endorsement instructions, you may need to increase or decrease the temperature of the endorsement according to the atmosphere in which you work. Thermometer . As for cooling the temperature of the appearance, resort to placing pieces of ice inside a nylon bag, then dip it
Inside the appearance cup with a temperature drop gauge down until it reaches a degree

required heat.

To cool the look, dip a nylon bag containing ice cubes into it.

3- Pour the appearance cup into the tank through the hole provided for that

The top of the tank.

Pour the appearance inside the closed tank through the hole designated for that, which does not leak light into it. - After closing the opening for pouring the solutions, grab the tank and shake it or turn it upside down every half a minute. This process is necessary to remove bubbles that form on the surface of the film and that affect the smooth running of the endorsement process.

Turn the tank upside down to remove bubbles that form on the surface of the film during endorsement.

E - Take the endorsement out of the tank after the end of the specified endorsement period by turning it upside down. If the apparel is of the disposable type, dispose of it by pouring it directly into the sink.
Take the look out of the tank by upside down.

- Pour the stop solution immediately into the tank and continue shaking the tank as you did before, with an interval of 15 seconds between each shake, for about a minute. In general, read the instructions accompanying the suspension solution to know the time required to stop. the bathroom

Casting bath endowment.

V 7- Remove the endowment bath from the tank and dispose of it in the washbasin, as this material is usually not suitable for repeated use.

- Pour the fixative solution into the tank, then shake it at intervals of 30 seconds between each shake, for a period of 5-10 minutes, as recommended by the instructions accompanying the fixative. 9 - Remove the stabilizer from the tank, and usually the stabilizer is not suitable for multiple uses, so get rid of it by dropping it on the sink basin, and if it is suitable for use several times, return it to its bottle with the help of the funnel. 10 - The film has now set and will not be affected by light. Remove the tank cover and place it in the washbasin, then open the water tap on the film inside to wash it for at least half an hour.